Catacomm Corporation
Sdn Bhd

Unit E1-29-6, Block E1,
Dataran Prima, Jalan PJU 1/42,
47301 Petaling Jaya,
Selangor, Malaysia.
+603-7803 8228
+603-7803 8228
clyeow@catacomm-corp.com

STM-1 to Ethernet 10/100BaseT Converter

Previous 6 / 6 Next

STM-1 to Ethernet 10/100BaseT Converter STM-1/4 & E3 Converters Series Interface Converters AD-Net
Quantity
Add Quotation


Description


AN-STM-1-ETH is designed as a STM-1 level optical modem with two 155.520Mb/s optical interfaces to provide a cost-effective and flexible multi-service platform. With 4 Ethernet interfaces compatible with IEEE 802.3/802.3u standard, it is easy to implement Ethernet transmission over SDH.
AN-STM-1-ETH supports port-based VLAN and IEEE 802.1Q tag-based VLAN. By adopting ITU-T G.7041, G.7042 and G.707-compliant EOS (Ethernet Over SDH) technology and VLAN technology, each Ethernet port can employs 1~4 separate Virtual Concatenation Groups (VCG), and each VCG can be assigned to one or more Ethernet ports. The bandwidth of VCG can be flexibly configured for efficient transmission of Ethernet data over SDH network.
AN-STM-1-ETH supports NE management based on CLI command and SmartView network management platform based on SNMP_V1 and SNMP_V2 protocol, to perform excellent management such as configurations, alarm monitoring and performance statistic.
AN-STM-1-ETH is suitable for data access network on the client side. With the technology compliant to ITU-T standards, it can communicate with products from other vendors adopting the same standards.
 

Features


  • Optical Interface
    • Two STM-1 interfaces, SFP optical module (LC connector), hot plug-in
      •  Complies with GB/T15941-1995 and ITU-T G.813 standards
      •  Supports RPD (Remote Power down Detection) information sending function
    • Supports ALS (Automatic Leaser Shutdown) to protect operators from hurt
  • Ethernet Interface
    • Four LAN ports(physical port), each LAN port supports auto-negotiation, it can also be set to 10M full/half-duplex, 100M full/half-duplex mode by force
    • Four WAN ports (internal port and invisible), each WAN port employs a VCG; the total bandwidth of 4VCGs is 63 VC12 and the bandwidth of each VCG is up to 48 VC12(100Mbps)
    • The LAN and WAN ports are compatible with IEEE802.3/802.3u standard
    • Supports flow control and broadcast storm filtering control
    • Supports port-based VLAN and IEEE802.1Q tag-based VLAN
    • Supports GFP-F Encapsulation specification complying with ITU-T G.7041
    • Supports VCAT specification complying with ITU-T G.707
    • Supports LCAS specification complying with ITU-T G.7042
    • Provides both LCAS and Non-LCAS modes
    • The maximum tolerated differential delay between any two VC-12 channels is 112ms
  • Protection
    • Supports 1+1 path protection with switching time less than 50ms
    • Supports Automatic protection mode and manual protection mode
  • Management
    • Provides serial management interface(CONSOLE) and Ethernet management interface (EMU), both adopt RJ45 connector
      • Supports network management based on SDH overhead or on internal E1 channel
      • Supports NE management based on CLI command via RS232 interface or TELNET
      • Supports SmartView network management platform based on SNMP_V1 and SNMP_V2 protocol to perform excellent management

Specifications

STM-1 optical interface:
Bit rate (bps): 155M
Optic ports£º2 optic SFP ports
 
Electric ethernet interface
Connector:              RJ-45
Work mode:    Support auto-negotiation and forced mode, the default is auto-negotiation
Speed:                     10M/100M
Duplex:            Full/half duplex
VLAN:                      Disable
Flow control:   Default: enable
Cable:                      CAT-5, cross-over and straight-through auto-detect
Standard:         IEEE802.3 10Base-T, IEEE802.3u 100Base-Tx
 
Ethernet management interface (EMU)
Bit rate:           100Mb/s
Connector:     RJ45
 
RS232 network management interface (CONSOLE)
Baud rate:               19200
Bits:                 8
Stop bit:           1
parity check:   None
Electricity level:      EIA-RS232 standard
Connector:              RJ45
 
Power supply
Input DC voltage:   -36¡«-72V DC
Input AC voltage:   100¡«260V AC
Power consumption:       Less than 15W
 
Environment requirements
Working temperature:    -5¡æ¡«50¡æ
Storage temperature:             -40¡æ¡«70¡æ
Relative Humidity:          ≤95%£¬no condensation
 
 
 

Ordering Information

 
 
AN-STM-1-ETH
STM-1 to Ethernet converter, single or multimode, or WDM up to 120 km, 48VDC or 220 AC/110 V AC.

 

Please leave your enquiry here, we will reply as soon as possible.
Name*  
Company Name  
Product Interested  
Quantity  
Email*  
Contact No.*  
Attachment  
*only support gif, jpeg, jpg, png, pdf
Messages*  

You have 0 items in you cart. Would you like to checkout now?
0 items
Switch to Mobile Version
Subscribe Newsletter