- AD-Net
- Video Audio Transmission Equipment
- RCA & XLR Audio Over Fiber Extenders
- HD Video Transmission
- CCTV Video/Audio/Data
- HDMI KVM Over Fiber
- HDMI KVM Over UTP Cat5e/Cat6
- VGA KVM Over Fiber
- VGA KVM Over UTP Cat5e/Cat6
- DVI KVM Over Fiber
- DVI KVM Over UTP Cat5e/Cat6
- AHD CVI TVI CVBS Over Fiber
- HDMI Over Wired & Wireless LAN
- USB Over Fiber Extenders
- Video Baluns (Video Over UTP Cat5)
- HD AHD/TVI/CVI Video Baluns
- HD AHD/TVI/CVI/CVBS Active Video Baluns
- FTTX Access
- Fiber Modules
- Industrial Communication Products
- Media Converters
- Fiber Optical Multiplexers
- n x E1 G.703 Series Fiber Multiplexer
- n x E1 G.703 Series + Ethernet Series
- Serial & CANBUS Fiber Modem Series (V.35/RS422/485/232)
- SNMP Managed n x E1/V35/ETH Fiber Multiplexer
- STM1/E3/DS3/T3 Fiber Mux Series
- Voice Over Fiber Mux Series
- Rack Mount Chassis
- CWDM Multiplexing Systems
- Optical Line Protection Equipment
- Interface Converters
- Passive Optical Equipment
- SDH/MSPP Systems
- Switches
- Video Audio Transmission Equipment
- Tainet
- Four-Faith
Catacomm Corporation
Sdn Bhd
Unit E1-29-6, Block E1,
Dataran Prima, Jalan PJU 1/42,
47301 Petaling Jaya,
Selangor, Malaysia.
+603-7803 8228
+603-7803 8228
clyeow@catacomm-corp.com16 x E1 Over IP | E1 Over Ethernet Multiplexer 每 Converter
Previous | 14 / 19 | Next |
In this video, we are connecting muxes to E1 BER tester at the remote end, and physically looping another end using 75-120 ohm BNC/RJ-48C baluns.
Description
As a cost effective solution for the traditional telecom services migrate to the IP packet networking technology, AN-TDM-IP-16E1 adopts the innovative TDM over IP technology, with IP circuit emulation that supports transportation of 8~16 E1s and 5 GE electrical ports and 1 GE optical port. The uplink ports and user data ports are IEEE 802.3 compliant, 10/100/1000M auto-sensed Ethernet ports.
State-of-the-art design provides the highest availability with the accurate timing signal and data bit stream reconstruction. Predefined system parameter profiles that according to different application requirement; ultimately simplify the installation process and saving the maintenance cost.
AN-TDM-IP-16E1 are able to work together with other members in TDM over IP family such as AN-TDM-IP-8E1, AN-TDM-IP-4E1, AN-TDM-IP-2E1, AN-TDM-IP-1E1 etc. to run legacy E1 services. Telecom and Enterprise users can save a lot of access and equipment costs and generates new revenue by offering different types of services over their packet-switched infrastructure. It is also suitable for connecting to the wireless equipment to achieve fast deployment of E1/T1 services. One particular application is to build E1/T1 links with low cost Wireless LAN bridges, replacing much more costly microwave radios. Operators can use H0FL-EthMux to provide legacy TDM services over wired or wireless Ethernet/IP network.
Features
-
Provide 5 GE electrical ports and 1 GE optical port, 6 GE ports serve as network uplinks or users ports, Anyone of 5 GE electrical ports may act as NM port.
-
Support Ethernet spanning tree protocol which enable normal work and protection in ring and mesh topology, protection resume in short time.
-
User-friendly Web server supported for easy setup and maintenance, alarm log provided.
-
Support SNMP V1/V2 network management.
-
Ethernet built-in layer 2 switch, support VLAN, comply with IEEE 802.3x, 802.1P.
-
Povide two pluggable E1 cards, each card supports 8 E1/T1s.
-
Point to point and point to multipoint supported.
-
Stable E1 clock recovery, low jitter and wander.
-
Low processing delay for E1 channels, high bandwidth usage efficiency.
-
Resist to packet loss, with PCM frame synchronization protection.
-
User definable encapsulation packet size for different application.
-
Support Ethernet encapsulation and UDP/IP protocol encapsulation.
-
Support VLAN settings for E1 service and in band VLAN management.
-
Enough jitter buffer to resist packet delay variation (PDV).
-
Local Ethernet port throughput limiting, assuring E1 QoS.
-
120Ω balanced E1/T1 port, RJ-45 connector, support 75Ω unbalanced port through outside converting cable.
-
Support cascade concatenate for more than 16 E1 ports.
-
Software and hardware online upgrade.
-
Power supply redundancy.
-
POE power supply supported by power module with 220V AC input and 55V DC output.
Specifications
Item
|
Description
|
|
Model
|
AN-TDM-IP-16E1
|
5 GE electrical ports and 1 GE optical port, 16 E1s
|
Interfaces
|
IP ports
|
5 GE electrical ports and 1 GE optical port
Comply with IEEE 802.3, 802.1Q, 802.1P
Speed and duplex auto-negotiation or manual
|
E1 Ports
|
16 E1 Ports Supported
Comply with G.703
Impedance: E1-120Ω or 75Ω
|
|
NM port
|
Same as IP ports
|
Web server and SNMP management supported
|
Power
|
Supply
|
Pluggable dual power supply
|
2DC or 2AC or DC+AC
|
||
-48V~-72VDC or 100‵240VAC
|
||
Consumption
|
≤15W
|
|
Working Environment
|
Temperature
|
0~ 50°C
|
Relative Humidity
|
≤90% (non-condensing)
|
|
Dimension
|
W x H x D (mm):
|
440 x 44 x 231
|
Application Scenarios
Webmanager available for remote monitoring and control:
Configuration examples:
Ordering Information
AN-TDM-IP-16E1
|
16E1 over Ethernet (TDM Over IP) multiplexer/converter, 5 GE electrical ports and 1 GE optical port, 16 E1s, 75/120 ohm, AC/DC power supply options.
|